Hi,
Handbuch.
Quote:
AuszugEnter Programming Mode
1. The Edge controller must be connected to a motor to sound beeps. Turn your transmitter on, and leave the Edge ESC unpowered. Move the transmitter stick to the top position (full throttle).
2. Connect battery power to the Edge ESC. The Edge ESC will beep its initialization tones when first plugged in. After a short period of time the Edge ESC will emit another short tone and the LED on the Edge ESC should flash a short, single flash that repeats. If the ESC flashes continuously it is not seeing a full throttle position. Move your throttle trim to the top position or increase your full throttle endpoint or ATV on your transmitter.
3. Move your transmitter stick to the middle position. The Edge ESC will emit another short tone, and the LED on the Edge ESC should flash a short, double flash that repeats.
4. Move your transmitter stick back to the top position again. After a short time, the Edge ESC will emit a short tone, and the LED on the Edge ESC should flash a short, triple flash that repeats.
5. Move your transmitter stick back to the middle position again. The Edge ESC will emit four short tones in a row, and the LED on the Edge ESC will start a repetitive flash sequence of a single flash followed by a long pause.
Also ... Vorbereitung:
. Sender an, Akku dran
. Modell Setup, Ändere Setup, Drehzahlreglereinstellung (ganz unten), Ausgabeeinstellung (Auswahl)
. Pitchkontrolle (x) Ein (Pitch-Gasknüppel ganz zurück)
. Stabi abstecken
Dann, nach Anleitung Castle
1. ...
2. ... etc. (Trim vergessen, haben wir nicht, müsste der Regler _eigentlich_ so einlernen -> sonst müsste man wiederholen, und zuvor die Endpunkte erweitern, versuchsweise vielleicht +/– 110)
Ich verstehe nicht ganz, warum Middle Position, aber der Regler ist ja nicht nur für Helis.
Ich würde vermutlich mal damit anfangen:
Quote:
AuszugManual Data Reset
Power controller up with TX & RX on and set to full throttle. The controller will chime the normal power up chimes. Leave TX at full throttle for 6 seconds after power up. The controller will emit a short tone after 1 second and then a long tone 5 seconds later. The controller will then erase the entire data log. Move the throttle stick to lowest position to arm the controller.
Die Factory Settings scheinen mir eigentlich bereits eine gute Grundlage.
Zu guter letzt könnte man (Pitchkontrolle (x) Ein) die Endpunkte noch so hindrehen, dass bei Knüppel zurück der Regler eben ausgeht, dann zur Sicherheit 5 Punkte drunter, und Vollgas (hören, LED) so, dass der Regler voll durchschaltet bei Knüppel vor.
Castle Link Software und USB-Dongle wären aber auch nicht ohne, weil ...
Link.
Welcher Regler mit welcher Firmware was kann erschließt sich mir aber auch nicht mehr, das ist Wissen von 2015 oder früher ...
Mei war das kompliziert ^^
Grüßle
Eddi
Born to fly ...
forced to work.