{"ok":true,"content":"RV wrote:<br> -------------------------------------------------------<br> Oh dear... one should only use controllers with<br> &gt; Built-in Mikado (bidirectional then) telemetry<br> &gt; Take it - then all of that is eliminated.<br> &gt;<br> How exactly did you proceed?<br> Does the ESC need to be switched on with full throttle or off?<br> &gt; become programmers?<br> &gt; When full throttle - the gas direct panel was also<br> &gt; NOT closed when disconnecting and connecting - and<br> &gt; then the warning will NOT be closed as long as<br> &gt; the messing took place?<br> Does he perhaps need extended gas lines beforehand (I mean)?<br> CC was always bad about that...)<br><br> Hello<br> Set the throttle to approximately 30 percent each time, then full throttle stick, then connect the controller until it beeps and...<br> Then increase the percentage each time until you hear a confirmation tone, and do the same for the throttle stick minus \u2013 done.<br><br> Regards<br><br> Regards","note":"machine-translated from German"}