← VBar NEO for external transmitters

VBar NEO (non VLink) important information translated

VBar › VBar NEO for external transmitters · Started by Eddi E. aus G. on 21 August 2015 12:4621.08.2015 12:46
Eddi E. aus G. 21 August 2015 12:4621.08.2015 12:46
Dear customers,

((German see below, Deutsch s. unten))

we are afraid we have to inform you about a small issue with VBar NEOs without VLink.

Some devices have been finished, packed and shipped which have a yellow sticker on the main board inside.
That is clearly visible from the outside e.g. with a flashlight or in bright light conditions.

Those devices have failed the after production test with different error codes, for different reasons, and thus have _no operational firmware_ on it.
This is intended and good, because customers (you :-) ) can not accidentally use them without contacting service.
It is very much possible that those devices are still good, but a human should check them and decide, this is why the automatic check sorted the devices out.

The devices in question will not connect to the setup software.

If you notice that your VBar NEO flashes a code in blue and red, but not the expected green-red before binding or solid blue after, please contact your dealer or us for a solution/a replacement.

Please excuse the inconvenience … we are very embarrassed about that :-(

This is not a safety issue, because devices which failed the after production tests are simply not operational.
If your device connects and is operational, it has passed all tests and can be used without any doubt.
VBar NEOs with built in VLink receiver are not affected.


Kind regards

Edward Eckstein
VStabi Service

//

Sehr geehrte Kunden,

wir müssen Sie leider über eine kleine Unregelmäßigkeit betreffend VStabi NEO ohne VLink informieren.

Einige wenige Geräte wurden konfektioniert, gepackt und verschickt, obwohl sie einen kleinen gelben Aufkleber im Innern auf der Hauptplatine haben.
Dieser Aufkleber ist gut erkennbar mit einer Taschenlampe oder bei hellem Licht.

Diese Geräte sind durch die Testreihe nach der Produktion gefallen, mit unterschiedlichen Fehlermeldungen, aus unterschiedlichen Gründen, und haben _keine funktionierende Firmware_ installiert.
Das ist so vorgesehen und gut, weil dadurch kein verdächtiges Gerät versehentlich von unseren Kunden in Betrieb genommen werden kann, ohne den Service zu kontaktieren.
Es ist gut möglich, dass die VStabi NEO trotzdem OK ist, sie müsste nur von einer Person noch einmal genau geprüft und bewertet werden. Dazu hat die Automatik die Geräte aussortiert.

Die betroffenen Geräte werden auch nicht mit der PC Software verbinden.

Wenn Sie feststellen, dass Ihre VStabi NEO einen Code in blau und rot blinkt, jedoch nicht das erwartete grün-rot vor dem Binden oder blau wenn OK, kontaktieren Sie bitte Ihren Händler oder direkt uns. Wir bemühen uns dann schnell um Ersatz für Sie.

Bitte entschuldigen Sie die Umstände ... die Situation ist uns sehr peinlich.

Es handelt sich dabei um kein sicherheitsrelevantes Problem, da Geräte, die durch den automatischen Test nach der Produktion fallen, schlicht und einfach nicht in Betrieb genommen werden können.
Wenn Ihre VStabi NEO verbindet und funktioniert, hat sie alle Tests bestanden und kann bedenkenlos eingesetzt werden.
VStabi NEO mit eingebautem VLink-Empfänger sind nicht betroffen.


Mit freundlichen Grüßen

Edward Eckstein
VStabi Service

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless