{"ok":true,"content":"Dear customers,<br><br> ((German see below, Deutsch s. unten))<br><br> we are afraid we have to inform you about a small issue with VBar NEOs without VLink.<br><br> Some devices have been finished, packed and shipped which have a yellow sticker on the main board inside.<br> That is clearly visible from the outside eg with a flashlight or in bright light conditions.<br><br> Those devices have failed the after production test with different error codes, for different reasons, and thus have _no operational firmware_ on it.<br> This is intended and good, because customers (you :-) ) can not accidentally use them without contacting service.<br> It is very much possible that those devices are still good, but a human should check them and decide, this is why the automatic check sorted the devices out.<br><br> The devices in question will not connect to the setup software.<br><br> If you notice that your VBar NEO flashes a code in blue and red, but not the expected green-red before binding or solid blue after, please contact your dealer or us for a solution\/a replacement.<br><br> Please excuse the inconvenience \u2026 we are very embarrassed about that :-(<br><br> <strong>This is not a safety issue, because devices which failed the after production tests are simply not operational.<br> If your device connects and is operational, it has passed all tests and can be used without any doubt.<br> VBar NEOs with built in VLink receiver are not affected.<\/strong><br><br> kind regards<br><br> Edward Eckstein<br> VBar Service<br><br> \/\/<br><br> Dear customers,<br><br> We regret to inform you of a minor irregularity concerning VBar NEO without VLink.<br><br> A few devices were assembled, packed and shipped, even though they have a small yellow sticker inside on the mainboard.<br> This sticker is easily visible with a flashlight or in bright light.<br><br> These devices failed the post-production testing series with different error messages for different reasons and have no working firmware installed.<br> This is by design and a good thing, because it prevents our customers from accidentally putting a suspicious device into operation without contacting customer service.<br> It&#39;s quite possible that the VBar NEO is still OK; it just needs to be thoroughly inspected and evaluated by a person. The automatic system has already filtered out the devices for this purpose.<br><br> The affected devices will also not connect to the PC software.<br><br> If you notice that your VBar NEO is flashing a code in blue and red, but not the expected green-red before binding or blue when OK, please contact your dealer or us directly. We will then quickly arrange a replacement for you.<br><br> Please excuse the inconvenience... we are very embarrassed by the situation.<br><br> <strong>This is not a safety-related problem, as devices that fail the automatic test after production simply cannot be put into operation.<br> If your VBar NEO connects and works, it has passed all tests and can be used without hesitation.<br> VBar NEO units with built-in VLink receiver are not affected.<\/strong><br><br> Best regards<br><br> Edward Eckstein<br> VBar Service<br><br> Born to fly ...<br> forced to work.","note":"machine-translated from German"}