← VBar Control Classic

Do the "pros" fly with or without expo? translated

VBar Control › VBar Control Classic · Started by Smartflyer on 15 June 2025 20:1915.06.2025 20:19
Smartflyer 15 June 2025 20:1915.06.2025 20:19
Hi,
I only recently switched to Vstabi and have always flown without expo until now.
The default settings are 30% on the TS and 50% at the rear.
I'd like to know how all the professionals and good 3D pilots set it up?
Do you fly with the standard settings, do you use less expo, or perhaps none at all?
(I always see in the videos that the helicopters hover negatively 10cm above the ground and do pirouettes like
It would drive me crazy. Without the Expo, I think I'd tear it apart immediately (but I haven't tried it yet).



Edited once. Last edited on June 15, 2025 at 8:20 PM by Smartflyer.
machine-translated from German · Show original
Eddi E. aus G. 16 June 2025 10:2216.06.2025 10:22
Good morning,

The expo values are traditionally chosen to correspond to the flight characteristics one might expect without flybarless or with other systems. Give or take.

I think about how many setups I've seen in service, many or most people don't even touch that.

And it's not about full deflection (maximum piro rotation rate on the ground, which is the same with or without expo), but about steering, about finer steering (rounded center).

Just try it. Two banks with identical settings, one without, one with expo. Or assign expo to a transmitter (assign parameter).

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless