← Logo 400 ... 690

VBar EVO micro V8 in the OMP M2 V3 Pro translated

Mikado Model Helicopters › Logo 400 ... 690 · Started by Lennart on 17 March 2026 08:4617.03.2026 08:46
Lennart 17 March 2026 08:4617.03.2026 08:46
Hi everyone,

I'm currently having a problem with my OMP M2 V3 Pro helicopter: slight oscillations in the tail, and I can't get rid of them. I recently installed the new VBar EVO micro V8 in the helicopter. When I install the original tail motor from the Logo 200 V8 in the OMP M2 V3 Pro, everything works as expected. However, when I switch back to the OMP's original tail motor, I get these oscillations.

What exactly could be the reason for this?

I also installed the regulator from the Logo 200 V8 into the OMP M2.

Is the Logo 200 profile in my VControl EVO+ possibly incorrect, and do I need to create a new model without the Logo 200 profile?
machine-translated from German · Show original
Eddi E. aus G. 17 March 2026 11:3917.03.2026 11:39
Hi Lennart,

What do the oscillations look like, and when do they occur?

What changes when you adjust the sensitivity or control behavior?

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Lennart 17 March 2026 16:3817.03.2026 16:38
Hi Eddi,

The oscillation occurs throughout the entire flight, as soon as the helicopter takes off. When I adjust the sensitivity and control behavior, the oscillation sometimes improves, sometimes worsens, but I can never eliminate it completely.

Is there any way to run the OMP motor with the VBar EVO micro V8? The OMP rear motor spins slower than the original Logo 200 rear motor.
machine-translated from German · Show original
Eddi E. aus G. 18 March 2026 08:4718.03.2026 08:47
Hello,

and ... how fast does it oscillate, and how strongly?

A short video might also be helpful.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
HeliALEX 20 March 2026 07:5020.03.2026 07:50
Hello Lennart,

What is your Tail Torque Extension set to?
If the large rear propeller is installed on the M2V3, you need to reduce these values, approximately 10-20.
machine-translated from German · Show original
Lennart 24 March 2026 13:4124.03.2026 13:41
Hello everyone,

I'll make a video of my commute when I get a chance. Maybe I'll manage it this weekend.

Thanks HeliAlex for the tip. I'll try that out too. I haven't touched the TTE value, so that might already be the solution.

Best regards
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless