← VPlane / VBasic VLink

VPlane with IC engines

VBar › VPlane / VBasic VLink · Started by James Salmon on 10 April 2015 10:0710.04.2015 10:07
James Salmon 10 April 2015 10:0710.04.2015 10:07
Will you adding the ability to enable throttle cut and idle trim adjust for IC engines? It may already be there but I couldn't find it. Right now the only to adjust idle or cut the engine requires me to go into the throttle adjust screen.



1 mal bearbeitet. Zuletzt am 10.04.2015 10:15 von James Salmon.
ulrich 10 April 2015 10:1810.04.2015 10:18
Motor OFF shall put the Motor off completely. On Idle it shall idle, and if you have idle on a Pot, you can adjust the Idle.
The Idle Value (if fixed) is banked, so you may select different idles depending on the selected bank. You find this in the "Throttle Settings"
Additional you may use the security switch to switch off the motor.

so long ... Uli
http://www.vstabi.de



1 mal bearbeitet. Zuletzt am 10.04.2015 10:25 von ulrich.
James Salmon 10 April 2015 10:2610.04.2015 10:26
Thanks Uli. How do I assign throttle low to one of the pots?
James Salmon 10 April 2015 10:4010.04.2015 10:40
Uli. I got it figured. I was looking at the throttle setup screen and not the Throttle screen. All works as needed now. Thanks for your help. Just need to get out and fly the model now.

Regards
ulrich 10 April 2015 10:4510.04.2015 10:45
Have fun!

Dont forget to assign and test the Autotrim switch, so you find it in flight...

so long ... Uli
http://www.vstabi.de
VStabi VStabi Pioneer of Flybarless