← Cafe

Is backup usage too high? translated

Public Talk › Cafe · Started by cc1975 on 27 February 2026 08:4927.02.2026 08:49
cc1975 27 February 2026 08:4927.02.2026 08:49
Hello everyone, after converting from 12 volt servos to 8.4 volt servos, I noticed the following:

With the 12 volt setup, I always had a consumption of 3-6 mAh in the backup in the log after the flight.
Now, at 8.4 volts, it's showing me 40-50 mAh. I don't notice anything during flight; there are no warnings. The rest of the setup remains the same. Is it possible that the new servos (MKS) are drawing so much more current or putting a strain on the BEC?
Should I perhaps add a capacitor to the EVO here to reduce current spikes?
Thanks, best regards, Christian
machine-translated from German · Show original
Eddi E. aus G. 27 February 2026 09:2427.02.2026 09:24
Hi Christian,

Since the backup system only runs at 8V, it will buffer more often during the normal voltage dips of 1-2V peak at 8.4V than at 12V... not unusual. If no warning appears, everything is fine; the (smoothed) warning threshold is not being triggered.

With the oscilloscope app on VBar Control Touch or EVO/+ and a VBar EVO, you can make the spikes visible; anything else would be guesswork :-)

Appropriate caps are of course always helpful for/against voltage spikes and back EMF.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
cc1975 27 February 2026 10:0327.02.2026 10:03
Thanks Eddi, that puts my mind at ease. Would a 2200 Ω capacitor be sufficient then? Mark Wiehenstroh suggested that as well.
Regards, Christian
machine-translated from German · Show original
Eddi E. aus G. 27 February 2026 10:2327.02.2026 10:23
Good morning,

Phew, someone with more knowledge would have to comment on that.

At the time, we tested 2-3 x 16 V/4700 µF in parallel (4.8-8.4 V and various power-hungry or back-voltage-prone servos), whereby the marginal benefit (does one more bring a noticeable improvement?) was actually already reached with 2, the third then only so-so.

Today, for example, probably 1 x 25 V / 5,800 µF?

2200 µF might be enough, or it was just there ^^
Or, of course, in competitive settings, it's always about space and weight.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless