← Cafe

micro heli receiver and telemetry OMP

Public Talk › Cafe · Started by Drav8r on 23 June 2026 23:1923.06.2026 23:19
Drav8r 23 June 2026 23:1923.06.2026 23:19
I just got an OMP M2V3 helicopter and installed the new micro heli receiver to use with my VBAR Control Evo. The SBUS connects fine and the heli controls work. However, the button to enable "VBar Control Telemetry" in the OMP app will not work. I updated my transmitter before installing this receiver. I have power cycled several times and deleted and reinstalled the app. Still the button for telemetry in the app will not work, it just goes back. No problem with the "S BUS range" which I set to Futaba, the button right above the telemetry button, which worked without problems. Is there something I need to check in macrocells? Did I perhaps get a flawed OMP control unit? Thank you.


I updated the firmware and it works now!



Edited 1 time(s). Last edit at 06/23/2026 11:38PM by Drav8r.

Aaronheli 24 June 2026 08:3224.06.2026 08:32
To enable Vbar telemetry you have to update your OFS3 firmware to min. version 15.20.

As I see you figured it out by yourself already. :-) :-)
VStabi VStabi Pioneer of Flybarless