Hello everyone
What settings do I need to configure to operate Aux 3 as a channel with a range of 0-100%?
Or is that not possible? I have three extension cables connected to the Aux input in my helicopter.
Installed to later control special functions such as lights, etc. via
Switch 2.
I wanted to try something out, but somehow I can't seem to reach my goal.
Regards, Bernd
Edited 1 time(s). Last edit at 06/16/2026 10:09PM by Berndi.
What settings do I need to configure to operate Aux 3 as a channel with a range of 0-100%?
Or is that not possible? I have three extension cables connected to the Aux input in my helicopter.
Installed to later control special functions such as lights, etc. via
Switch 2.
I wanted to try something out, but somehow I can't seem to reach my goal.
Regards, Bernd
Edited 1 time(s). Last edit at 06/16/2026 10:09PM by Berndi.
Hallo zusammen
Was muss ich Einstellen um Aux 3 als Kanal 0-100% zu betreiben?
Oder geht das nicht. Habe in einem Heli im Aux 3 mal ein Verlängerungskabel
Verbaut um später mal Sonderfunktionen wie z.B. Licht etc. anzusteuern über
Schalter 2.
Wollte jetzt mal etwas ausprobieren aber irgendwie komme ich nicht ans Ziel.
Gruß Bernd
Edited 1 time(s). Last edit at 06/16/2026 10:09PM by Berndi.
Was muss ich Einstellen um Aux 3 als Kanal 0-100% zu betreiben?
Oder geht das nicht. Habe in einem Heli im Aux 3 mal ein Verlängerungskabel
Verbaut um später mal Sonderfunktionen wie z.B. Licht etc. anzusteuern über
Schalter 2.
Wollte jetzt mal etwas ausprobieren aber irgendwie komme ich nicht ans Ziel.
Gruß Bernd
Edited 1 time(s). Last edit at 06/16/2026 10:09PM by Berndi.
machine-translated from German · Show original