← Cafe

Battery ID sensor for VBar-Control translated

Public Talk › Cafe · Started by Rainer2019 on 31 October 2026 13:3531.10.2026 13:35
Rainer2019 31 October 2026 13:3531.10.2026 13:35
Hi Eddi,

Since I not only had to blow out the pitot tube, but also replace the fuselage with a new one (you know, because of the dirt from the field), I now also plan to install the battery ID sensor that I bought two years ago.
Unfortunately, the sailboat doesn't offer enough space.
Therefore, I was forced to opt for a sandwich construction (controller -> 2-3mm air gap -> antenna surface -> 5mm board -> battery with ID tag on the underside).
It works so wonderfully, but I don't yet know what to expect during the flight.
Do you have any concerns regarding this?

greeting
Rainer



Edited 1 time(s). Last edit at 10/31/2026 01:39PM by Rainer2019.
machine-translated from German · Show original
Eddi E. aus G. 2 November 2026 09:1502.11.2026 09:15
Hi Rainer,

If the sensor detects the daytime, then it's OK.

The data is only captured once when the device is switched on; once the battery is selected, it does nothing more (as if the battery had been selected manually). It can also be captured if you manually switch the day via the battery management settings, but that doesn't happen instantly.

It's all ok!

—Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Rainer2019 2 November 2026 16:4302.11.2026 16:43
Hi Eddi,
That's good to hear. So, all the best until the next crash, which I hope is a long way off!
greeting
Rainer
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless