← VPlane / VBasic VLink

Re: Surfaces - Programming translated

VBar › VPlane / VBasic VLink · Started by Mario Frascoia on 10 January 2026 13:4710.01.2026 13:47
Mario Frascoia 10 January 2026 13:4710.01.2026 13:47
Hello everyone,

I just can't seem to program my ailerons upwards for landing (as brakes), I've already tried for 3 hours.

I use a VBar Neo and a VBar Control Touch Evo.
My model setup is: Standard + Flaps.

Does he provide instructions for this?

Regards, Mario
machine-translated from German · Show original
RV 10 January 2026 22:4010.01.2026 22:40
Hi Mario,

Please no thread hijacking - I've split it off.

If you want to position the QR code facing upwards, you must enter the input as follows:

MC09 is the "input cell" for the wing mixer for the ailerons. It normally contains a channel with a delay. As far as I know, this is controlled by MC20 (or MC27?) as a 3-level switch (LK switch).

Now do the following:

- MC 09 becomes a mixer, input 1 e.g. MC21, input 2 MC22
- MC 21 includes the channel as above on 09 with the LK Delay.
MC 22 is now the input for your specific case. You can then configure it as you see fit (3 levels, switches, delay, joysticks - whatever is needed).

Should you also want to set the QR in parallel - here you place an MC with a mix on itself at the QR outputs (QR goes through), 2. crochet the mix input as above.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
machine-translated from German · Show original
Mario Frascoia 11 January 2026 19:3511.01.2026 19:35
Hello Mr. Vetter,
I'll try it, thank you very much.

Regards, Mario
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless