Pawel Plesniak
1 February 2026 23:1101.02.2026 23:11
Hi, I have a Vbar Evo but the one of the telemetry port stop working suddenly. I had connected vbar power backup mini and now I don’t seen it VControl Evo transmitter. I swap ESC telemetry cable to see if the cable from backup power is faulty but esc telemetry not working as well which mean the port is faulty. Is the anything I can do to check it our fix it or you recommended send to the Mikado shop. By the way unit working fine just the port now working. What you advise?
Thanks Pawel
1 mal bearbeitet. Zuletzt am 01.02.2026 23:12 von Pawel Plesniak.
Eddi E. aus G.
2 February 2026 09:3602.02.2026 09:36
Hi Pawel,
hard to tell, from remote. Which TELE port is it?
With VBar EVO VLink, you can force TELE1 (the 'front' port, pointing to the servo connectors) to Temperature Sensor only (Model Setup, Telemetry, VBar EVO Options), but that wouldn't change suddenly or on it's own.
Still worth checking out.
Another basic check would be, check the voltage on the connector, using a multimeter.
Careful not to cause a short circuit ;-)
If it's just the port and if you're OK with it (daisy chain telemetry items, connect to the working port), that'd be one way to 'fix' it (or work around it ...).
Otherwise you can of course open a service ticket at vstabi.info/devices and we can check it for you.
If it was just a broken soldering joint, and if there was still something to solder back onto, it's repairable.
If not, or if the port somehow took the soldering pads or conducting paths with it, probably not—then, you'd be back to square one (keep using it with just one port), or we could discuss a replacement and software license transfer.
Best,
Eddi
Born to fly ...
forced to work.
2 mal bearbeitet. Zuletzt am 02.02.2026 09:37 von Eddi E. aus G..