← VBar NEO/EVO VLink

Vlink antenna length

VBar › VBar NEO/EVO VLink · Started by PeteStewardson on 28 March 2026 18:2728.03.2026 18:27
PeteStewardson 28 March 2026 18:2728.03.2026 18:27
I just got a new Vbar Evo Vlink and noticed something odd, the exposed part of the antenna seem to be shorter than the other 3 I have? Is this normal?


If not, rather than mess about returning it, can I buy new antenna to fit the EVO?

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Bernd S. 29 March 2026 10:4429.03.2026 10:44
Hello,

you will be get an much more qualified reply from Mikado.

But the Lenght of the isolated Part of the Antenna depends on the exact type of coaxial Cable.

So - if the Cable differs -> the Length differs to ( Thickness of the inner Wire and Dielektrikum witch is around the inner Wire ) .

You should do an outdoor-Range Test like Mikado explained.

Or you could measure if you got the Equipment ( RF-Analyzer or such Things ).

I assume Mikado knew what they do, my Rangtest with my new Evo shows in 10m Distance around the Heli shows nearly maximum - so all seems to be fine.

If you are interrested in i could do an Measurement with my new spare Antennas for the Neo/Evo.
( Mechanical and RFrequency )

This Kind of Antenna does not work perfekt - the Environments matters much.

Wait for the Answer from Mikado Profis - i am only an Amateur.

Greets and sorry for my English !

Bernd
ulrich 30 March 2026 12:0730.03.2026 12:07
Are you an Radio Amateur Bernd? Sounds knowlegable!

The official Length is 29mm. It happens that the inner conductor slides out or in a bit (+-1mm), but that does not make a noticeable difference. Indeed the more important parameter is the cable itself, length, geometry, material and the placement.

It is very difficult to get clean reproducable measurements with the vector network analyzer, since it depends very much on the environment how the antenna is placed. This type of antenna does not have a defined RF counterweight, so the total performance can only be measured at the actual mounting position. Thats the reason i usually recommend using our antenna mount on the conductive tail boom if possible. This is the reference setup.

The type of antenna is not optimal, but its a accepted compromise which has enough sensitivity for our application. The Problematic part is usally not the reception, but when the telemetry is transmitted. If the SWR is too bad, the Poweramp gets unstable and violates the Certification.

Conclusion: +-1mm is fine, it the deviation is more, better replace. In any case, the Rangecheck is the only thing that matters.

so long ... Uli
http://www.vstabi.de
PeteStewardson 30 March 2026 12:1030.03.2026 12:10
Hi uli,

Is MIK5063 the correct antenna replacement for an Evo vlink?

Pete

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
ulrich 30 March 2026 12:2130.03.2026 12:21
Yes, they are correct.

EVO and NEO do have the same Antenna Parameters.

so long ... Uli
http://www.vstabi.de
PeteStewardson 30 March 2026 12:2230.03.2026 12:22
Thanks, I'd rather just put some new ones on than return it and set up a new one all over again :-)

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Bernd S. 31 March 2026 21:1131.03.2026 21:11
ulrich schrieb:
-------------------------------------------------------
> Are you an Radio Amateur Bernd? Sounds
> knowlegable!

seems to to be true :-)

I like Ghz :-)

As written, there are "better" Antenna Types - but this works ok in RadioControlHelis/Devices.

The noticeable Difference starts to happen with an defined Counterpoise - and then it becomes more "userunfriendly".

Jeti did it with there Coaxialantenna-Type ( looks link an "Sperrtopf" but this was not an "Sperrtopf" )

- and Jeti does not do it anymore ( to complicated ? )

Dont worry - make Rangetest - fly and start the Grill with nice Sausages ( or veggi ) .
VStabi VStabi Pioneer of Flybarless