← VBar NEO/EVO VLink

nitro throttle NEO v EVO

VBar › VBar NEO/EVO VLink · Started by cudaboy_71 on 13 June 2026 18:0113.06.2026 18:01
cudaboy_71 13 June 2026 18:0113.06.2026 18:01
edit:
i just reset the EVO and it is fine now; just a glitch


I am switching my NEO for EVO on a nitro model.

During setup everything is straightforward as usual except when I am setting up Nitro throttle endpoints and kill switch.

Nothing has changed mechanically on the model. But, the servo is now backward from the NEO.

This is fine—I just use the servo reverse button. But, now when I hit motor kill instead of reducing to zero, it goes to full throttle :-) That would be scary if I didn't scroll down to remember to check motor kill position!!!

Is this a change from NEO to EVO? Or is there some way to reverse the motor kill direction, too?

As of now, it appears the throttle reverse function is useless. I'll just have to make the servo horn push from the other side. But, I'll wait to hear if there's a solution I'm missing.



1 mal bearbeitet. Zuletzt am 13.06.2026 18:16 von cudaboy_71.
VStabi VStabi Pioneer of Flybarless