← VBar NEO/EVO VLink

vstabi problem translated

VBar › VBar NEO/EVO VLink · Started by linken98 on 30 January 2026 13:5530.01.2026 13:55
linken98 30 January 2026 13:5530.01.2026 13:55
Hi,

I tried to install my VBar Evo today, but the roll movement on channel 1 isn't working properly. Channels 2, 2, and 4 work perfectly fine. What could be the problem? I've also tried swapping servos, but it's only happening on channel 1.

Best regards, Sascha



Edited once. Last edited on 30.01.2026 at 14:13 by linksen98.
machine-translated from German · Show original
Eddi E. aus G. 30 January 2026 14:5430.01.2026 14:54
Hi Sascha,

um... on H-3, HR-3 and H-4, CH1 is the 'pitch' servo, which does nothing for roll... and shouldn't, as long as no swashplate rotation is programmed.
For H-1 it would be Pitch ...

Please provide more information about the type of helicopter, components, etc.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
linken98 30 January 2026 15:0130.01.2026 15:01
I have an HR-3, channels ch1, ch2, and ch3 are assigned. On ch1, when I control pitch and yaw with my VBar, everything works normally, but when I try to control roll, nothing happens, only pitch and yaw. I connected it according to the instructions and even checked the PC software. Even when I swap the servos, the same problem with roll persists on ch1.

Set up
Vbar Control (1st Generation)
vbar evo (not pro)
ALIGN DS820M tumble disk servos (had no problem with the Vbar neo before)
2s LiPo power supply for adjustment
machine-translated from German · Show original
linken98 30 January 2026 15:0430.01.2026 15:04
Lol, I'm so stupid, CH1 is only supposed to do nick and pitch, how could I... it's been too long.
machine-translated from German · Show original
Eddi E. aus G. 2 February 2026 09:2502.02.2026 09:25
:-)

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless