← VBar NEO/EVO VLink

YGE Aureus 135 controller and VBar Neo translated

VBar › VBar NEO/EVO VLink · Started by 590423 on 23 April 2026 18:5523.04.2026 18:55
590423 23 April 2026 18:5523.04.2026 18:55
Hello everyone,
Subject: Error message with YGE controller Aureus 135 and VBar Neo.
The error message “Sensor check number error” appears several times per flight.
I tried both controller modes: YGE controller mode or VBar controller mode.
It is not noticeable when flying.
What can I do to solve the problem?
Thank you in advance for your feedback.
greeting
Philippe
machine-translated from German · Show original
RV 23 April 2026 22:1223.04.2026 22:12
Please post the complete VBar log here.

Question: Is an external gyro sensor connected to this VBar?

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
machine-translated from German · Show original
590423 23 April 2026 22:4623.04.2026 22:46
Good evening Rainer,
An external gyro sensor is not connected.
Attached is a zip file of the log file.
greeting
Philippe
machine-translated from German · Show original
Eddi E. aus G. 24 April 2026 09:0324.04.2026 09:03
Good morning,

What is connected where and how (especially anything at the sensor connection next to the USB?), and where is the VBar installed?
There have been cases where the RPM cable (speed signal) was plugged into a sensor, not the RPM unit...

Grüßle

Eddi

Born to fly ...
forced to work.



1 mal bearbeitet. Zuletzt am 24.04.2026 10:08 von Eddi E. aus G..
machine-translated from German · Show original
590423 24 April 2026 09:3424.04.2026 09:34
Good morning,
The problem is solved; the RPM cable was connected incorrectly.
Thank you so much for your help.
Kind regards
Philippe
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless