← VBar Control Classic

Macrocells old Vbar Control and VBar NEO Micro Rx

VBar Control › VBar Control Classic · Started by rubig15@hotmail.co on 7 January 2025 13:1707.01.2025 13:17
rubig15@hotmail.co 7 January 2025 13:1707.01.2025 13:17
Hi guys! A few days ago I saw this video from Richard about configuring an OMP with the new micro receiver using the macrocells, in the video description he attaches the file with everything needed but I see that he uses a Vcontrol Touch.

Could this file be included in the old normal Vcontrol? Or can it only be done with the Touch and Touch EVO models?

I ask since it is quite easy to download the file and include it in the transmitter, but I do not know if this can be done with the old Vcontrol and maybe I buy a second hand one from a colleague!

Maybe this is a very obvious question but I'm completely new to Vcontrols, I've been flying Vbar for years but this is the first Mikado transmitter I'm going to have and I want to make sure this can be done :-)

This is the video:

https://www.youtube.com/watch?v=7FBGHg7ZOJg
Eddi E. aus G. 7 January 2025 14:3207.01.2025 14:32
Hi,

technically, you can save the setup from any VBar to any VBar Control (a set of parameters, that is), and then copy it from there or from it's Cloud onto a different VBar Control and load it to a similar/identical unit (hardware/firmware). You can even do that with the computer software, where applicable (RX Only don't connect to the computer).

But there is no safety net, in case the file is a dud or from a different unit/version, the unit can malfunction.
It's not dead, then, just confused :-) , when you do a new setup you overwrite the existing one with works parameters, and all is well again.
But of course the malfunction can lead to servos running to their limits, motors/ESCs to start, so take the usual precautions when loading any foreign setup file.

So basically, download it, copy it to the /vbar folder on your VBar Control classic, bind your RX Only, use Model Setup / Model Tools to Load the Setup to it, job (probably ^^) done.

Kind regards

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless