Hi,
I'm using a NEO with rescue together with a Futaba T10J and it all works fine but I have some questions:
1. What parameters are actually stored in the separate banks? Is it all paramaters that exists, i.e. swash type, receiver type, sensor orientation etc. I noticed that the rescue pitch can be different for different banks (which is good) but are e.g. the rescue level calibration be different for different banks?
It would be a good thing if the parameters that can be different for different banks in some ways are marked in the setup program.
2. Is there a maximum time for the heli to reach level mode? E.g. if I run with very low headspeed on a "sluggish" heli, will the algorithm give up after a specified time or will it continue until the heli is level?
3. If I set the rescue channel to a 3 way switch I noticed in the PC program that the rescue mode switches between "level" "off" and "rescue". What is the difference between "level" and "rescue"?
Finally, I really think it should be possible to adjust the governor value by changing the throttle level in the Tx. Now I need a laptop at the flying field which is quite inconvenient.
Anyway, the NEO seems to work very well and the rescue function is great!
I'm using a NEO with rescue together with a Futaba T10J and it all works fine but I have some questions:
1. What parameters are actually stored in the separate banks? Is it all paramaters that exists, i.e. swash type, receiver type, sensor orientation etc. I noticed that the rescue pitch can be different for different banks (which is good) but are e.g. the rescue level calibration be different for different banks?
It would be a good thing if the parameters that can be different for different banks in some ways are marked in the setup program.
2. Is there a maximum time for the heli to reach level mode? E.g. if I run with very low headspeed on a "sluggish" heli, will the algorithm give up after a specified time or will it continue until the heli is level?
3. If I set the rescue channel to a 3 way switch I noticed in the PC program that the rescue mode switches between "level" "off" and "rescue". What is the difference between "level" and "rescue"?
Finally, I really think it should be possible to adjust the governor value by changing the throttle level in the Tx. Now I need a laptop at the flying field which is quite inconvenient.
Anyway, the NEO seems to work very well and the rescue function is great!