Pawel Plesniak
30 July 2015 14:5330.07.2015 14:53
Hi Guys,
I was testing my new Vbar neo yesterday. I was hovering inverted and I flick rescue switch and I didn't work. I landed disconnect the batteries then connected again. I tried again and it worked but only once. I try to use rescue mode again and I didn't work at all. I'm using Futaba 14sg transmitter. Maybe I'm missing something with the set up?? Or is the bar neo faulty?? Any solution to my problem.
Thanks for any information,
Pawel
1 mal bearbeitet. Zuletzt am 30.07.2015 14:57 von Pawel Plesniak.
RV
30 July 2015 15:0930.07.2015 15:09
Which TX / RX ?
What is shown in the TX calib screen in the rescue fields (text) with not active and with active switch?
Did you mention our examples here on this page and set up according to them?
regards (EN) / Gruss (DE)
Rainer Vetter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.
Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
1 mal bearbeitet. Zuletzt am 30.07.2015 15:09 von RV.
toddiebandit
31 July 2015 00:0231.07.2015 00:02
Hi,
remember that you have 3 statis for the rescure function.
For switching of the function you have to have the neutral signal on rescure channel. So for rescure and switching of you need to specify -100% and 0% on servo channel, not -100% and +100%
In live view you will see Active and OFF for your rescure switch. If you see Active and Level it is wrong and only working once.
-Torsten
Pawel Plesniak
1 August 2015 21:3201.08.2015 21:32
toddiebandit schrieb:
-------------------------------------------------------
> Hi,
> remember that you have 3 statis for the rescure
> function.
> For switching of the function you have to have the
> neutral signal on rescure channel. So for rescure
> and switching of you need to specify -100% and 0%
> on servo channel, not -100% and +100%
> In live view you will see Active and OFF for your
> rescure switch. If you see Active and Level it is
> wrong and only working once.
>
> -Torsten
Hi,
That was the problem. The rescue mode work perfectly now.
Thanks for advice,
Pawel