alexn
19 August 2015 10:3619.08.2015 10:36
Hello.
Neo has three modes bailout functionality:
1. Rescue
2. Beginner
3. Rescue + Beginner
I don't understand how to manage these modes with a single channel "Rescue"?
Sorry for my English.
Best regards, Alexey
Eddi E. aus G.
19 August 2015 11:1419.08.2015 11:14
Hi,
your channel must provide three positions:
Endpoint one: Rescue
Center: Off (normal flight operation)
Endpoint two: Beginner (tilt angle/speed limitation)
If you want to use different switches or a push button for Rescue and a switch for Beginner, you have to set it up using the programming logic of your radio, and check that the functions work properly and as intended.
Mind that you have to switch to Off before you can trigger a new rescue, so the center position is important.
If you switch between Rescue and Beginner only, it can happen that a second rescue attempt might fail (no rescue).
Kind regards
Eddi
Born to fly ...
forced to work.
alexn
19 August 2015 12:0319.08.2015 12:03
Hello Eddi,
do I understand correctly that switching from Beginner to Rescue and back (i's important) must necessarily be done through Off? If answer is yes, what is delay needed to Off?
Best regards, Alexey
2 mal bearbeitet. Zuletzt am 19.08.2015 12:10 von alexn.
Eddi E. aus G.
19 August 2015 12:3119.08.2015 12:31
Hi Alexey,
from Beginner to Rescue, no problem.
To prep Rescue again, if the switch goes to the Off position or through the Off position back to beginner (3-position switch), it's enough.
If you use the programming logic of your radio to mix different switches (e.g. a push button and a switch), I would recommend a delay of 0.5 secs just for good measure. You can test it on the bench: if you re-trigger rescue, the swash plate must act, and a log file entry must occur (Bailout start/end).
Unfortunately, you can never test all permutations of devices, programming possibilities. What works on some or maybe even most radios (e.g. without delay) must not necessarily work on all radios.
Kind regards
Eddi
Born to fly ...
forced to work.
1 mal bearbeitet. Zuletzt am 19.08.2015 12:31 von Eddi E. aus G..
alexn
19 August 2015 22:3319.08.2015 22:33
Hello Eddi,
tests showed that no important how switched from Beginner to Rescue and back, through Off or passing Off. Swash act any case.
However (IMHO) return mode Beginner not performed correctly. If after Rescue switch to Normal flight operation (Rescue off) - swash slowly returns to position collective pitch set on transmitter. If after Rescue switch to Beginner (through Off e.g. 1 second or passing Off) swash sharply returns to position collective pitch set on transmitter. This can lead to a dramatic change altitude and crash.
Best regards, Alexey
3 mal bearbeitet. Zuletzt am 19.08.2015 22:40 von alexn.
alexn
27 August 2015 13:0327.08.2015 13:03
Hello Mikado Team!
You can comment on my last post?
Regards, Alexey
Eddi E. aus G.
27 August 2015 14:1027.08.2015 14:10
Hi,
you mean that you would want the soft handover for collective also if you directly switch back from Rescue to Beginner, do I get that right?
Kind regards
Eddi
Born to fly ...
forced to work.
alexn
27 August 2015 14:3327.08.2015 14:33
Hello Eddi,
yes, right.
Regards, Alexey