Acrow
26 August 2015 09:3926.08.2015 09:39
Hi
I have an 11 channel DSM2 transmitter. I have found that I am unable to assign channel 8 or higher to Neo using DSM2 satellites. Is this expected?
Could I utilise more channels with Neo using DSMX satellites to which my transmitter would connect in DSM2 mode?
Regards
Acrow
1 mal bearbeitet. Zuletzt am 26.08.2015 10:10 von Acrow.
Eddi E. aus G.
26 August 2015 13:0426.08.2015 13:04
Hi,
afaik with 22 ms, only 8 CH are possible. With 11 ms, more. But I have not tested myself.
So if your satellites only bind with 22 ms (which is a thing between radio and sats), that could be the issue.
Kind regards
Eddi
Born to fly ...
forced to work.
ulrich
26 August 2015 22:0226.08.2015 22:02
In theory DSM Protocol allow 16 Channels that all can be adressed in VBar. It depends on the Transmitter, which channels are used an transmitted.
so long ... Uli
http://www.vstabi.de
Acrow
28 August 2015 10:0028.08.2015 10:00
Hi Team
Thanks for the prompt reply.
I am still unsure for the channel limitations. My DMS2 satellites properly pair with a JR RD1221 and drive 12 channels. Therefore the Neo limitation must be downstream of the remote receiver. It look like it is within the Neo design.
Regards
Acrow
ulrich
28 August 2015 11:1228.08.2015 11:12
That sounds correct. I just checked it in the code, but there is only a limit at 16 Channels, which is all the data allows.
Maybe they use a special trick, but there is no general limitation. How do you find that limit? Did you try all Channels from 8..16 to find some signal?
so long ... Uli
http://www.vstabi.de
Acrow
28 August 2015 23:4028.08.2015 23:40
Hi Uli
Thanks again for the quick response.
I tried mapping all available channels using DMS2 mode. Neo would assign channels 1 to 7 correctly but could not recognise channel 8 or higher.
Regards
Acrow