hirobo
17 September 2015 14:2117.09.2015 14:21
Hi
I'm confused to setup Electric Gov:
http://www.vstabi.info/en/node/2031
I have to curve V on radio ??
I must set the maximum rpm Vbar and down the radio throttle curve to arrive at rpm sought ??
Sorry for my English
Eddi E. aus G.
17 September 2015 14:2517.09.2015 14:25
Hi,
no curve in the radio. What you see in the link is how the Governor operates.
In fact, the radio's throttle curve is no longer routed through to the VBar NEO _unless_ you assign throttle to AUX3 (then you would have to use a mix channel to tell the VBar NEO the throttle status OFF-IDLE-RUN.
From the radio, you only switch banks and enter a desired head speed for each bank.
On most installations, nothing more is needed, the default parameters work very well.
Kind regards
Eddi
Born to fly ...
forced to work.
hirobo
17 September 2015 14:4017.09.2015 14:40
I use esc YGE Mikado 160HV in t-rex 700.
With Vbar silver soft start was good.
with Neo soft start was a little fast, which leave less aggressive ??
Eddi E. aus G.
17 September 2015 15:0217.09.2015 15:02
Hi,
for the soft start, you can adjust the runup limit (Gov. Expert) to try if it makes a change.
Please also check using Gov. II panel / Throttle adjustment if the end points match the ESC's ... no need to re-program the ESC but maybe to adjust a few percent left or right for motor off and full throttle.
I did not find a notable difference between Mini/Silverline and NEO regarding that, but if the Mini/NEO was tweaked a litte different ..?
Kind regards
Eddi
Born to fly ...
forced to work.
hirobo
17 September 2015 15:1317.09.2015 15:13
I will review the setup
Thank Eddi