← VBar NEO for external transmitters

NEO non Vlink and No GOV, just CURVES and Sub Trim

VBar › VBar NEO for external transmitters · Started by Rusty on 20 October 2015 15:3220.10.2015 15:32
Rusty 20 October 2015 15:3220.10.2015 15:32
NEO non Vlink and No GOV, just CURVES and Sub Trim
Good morning, i am setting up a new NEO and excited to fly it!,

but is there a way to bypass the Gov on a nitro, as the older silver line allowed for by not choosing the gov at all...
and if not how do i get the sub trim to become active on the radio,

JR 11X
Neo non Vlink


my mech set up on throttle is a perfect 100 -100 in the radio and the vbar....no binding so it should work,
i noticed there is an idle number in the gov menu now...but on a nitro need to be able to set with the radio if possible.

Thank you so much for any help.

Rusty :-)
RV 20 October 2015 19:3720.10.2015 19:37
Quote:but on a nitro need to be able to set with the radio if possible

You can get access to this and many other parameters in flight with a VBar Control. For other radios - there is no way as it is not a "channel" in the old radio language anymore.

Have you seen that there are AUX2 and AUX3 outputs? What about assigning the Radio throttle / ext. gov rpm there and feeding those outputs for a ext. gov / throttle servo ;-) - use AUX3 for the throttle from TX - it has a failsafe (no signal) in case of RX failure.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
Rusty 20 October 2015 20:4620.10.2015 20:46
Hey thx so much for the response...AUX 3 has crossed my mind, think i may look into that! THX again. :-)
VStabi VStabi Pioneer of Flybarless