← VBar NEO for external transmitters

Neo On Gasser translated

VBar › VBar NEO for external transmitters · Started by fastflyer20 on 23 December 2015 14:3423.12.2015 14:34
fastflyer20 23 December 2015 14:3423.12.2015 14:34
Hello, I have been flying the Neo on a gasser and the flight characteristics are fantastic. It is one of the best gov's once in flight.
I like to fly many different head speeds. The Leviathan Goblin and new TRM engines allow a very wide range of head speeds making it a very versatile helicopter.

Not using a V Control sounds OK on a electric but is very limiting on a gasser. The engine should warm up for around 30 seconds before it is flown, this takes a bank which means only 2 banks are left for idle up. Not being able to control idle point without a PC is also a big disadvantage. A friend has a V Control and it is very easy for him to make changes that are impossible in a different TX or without a PC.

Some suggestions:
1) 2 more banks - This would allow a dedicated bank for a normal curve without loosing head speed choices.

2) Run Up Speed - Allow different setting for each bank. This would make it possible to set it to 1 for slow start up at low head speeds and at 2 or 3 for higher head speeds where auto's are usually done.

3) If it is possible, allow trim to be adjusted in TX. This is a big problem when starting a cold engine.

Vbar has done a great job, a few additional changes for pilots using a different TX would be a big benefit.

While I am not an expert, below are videos of flying at 1400, 1800 and 2050 with Neo gov. 1925 is also a great head speed but not easy to change without using a PC.


https://www.youtube.com/watch?v=oC4YM0vobvc

https://www.youtube.com/watch?v=8fGsm7mXfY4

https://www.youtube.com/watch?v=NdZSYv9HmFE
VStabi VStabi Pioneer of Flybarless