← VBar NEO for external transmitters

Vbar NEO with Kontronik Jive translated

VBar › VBar NEO for external transmitters · Started by mahathyr on 30 December 2015 03:3830.12.2015 03:38
mahathyr 30 December 2015 03:3830.12.2015 03:38
Hi guys,

i have vbars on all my birds but i have never used bankswitch or vbar gov and has always been utilising the kontronik gov.

but now with my friends Neo im having issues on setting up the esc.

we're using DX7 with DSMX's sats binding at 22ms frame rate (not sure if this is right or should we bind at 11ms?)

I have gone tru the setup but on the 1st page of gov tab i have selected external gov and didn't do anything on the 2nd tab and just clicked finish.

we setup the kontronik jive 100lv as per normal mode 4 and set throttle curves on the tx 60, 70 , 80 and did the maiden.

at 60% the headspeed was super low and at 70% headspeed was super high and at idle 2 there was no change.

is there anyway where we can setup the vbar neo like the old vbars and use it without the bankswitch and internal gov and use the kontronik gov?

will appreaciate any advise. cheers.
RV 30 December 2015 08:4330.12.2015 08:43
First - the banks are mandatory. Just see them "as the same" as a flight condition in TX - but it is now located in the VBar.

Second - if you want to control the ESC by TX - see here:

http://vstabi.info/en/neo_transmitter




Quote:at 60% the headspeed was super low and at 70% headspeed was super high and at idle 2 there was no change.

Maybe you tried to teach stick inputs new?

Re-Programm Mode 1 and then 4 on the ESC.

- calibration check collective (-100 / +100) stick
- Gov 2 tab, enable stickmode
- unpower all

now you can use the collective stick for next powerup to program. After it is done - uncheck in Gov 2 of course!

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
VStabi VStabi Pioneer of Flybarless