← VBar NEO for external transmitters

Adjusting cyclic throw translated

VBar › VBar NEO for external transmitters · Started by duc996bp on 25 January 2016 16:2925.01.2016 16:29
duc996bp 25 January 2016 16:2925.01.2016 16:29
Hi

I have another question on my new setup, 550sx and NEO (Pro-rescue)

I'm just completing the setup, have done this before on my TDR so know the process.

Using the STD method my cyclic is giving a value about 90 at 8 deg. When I try the expert method there is no difference in the position of the blades between "position 1" and "position 2", the "start position" is 0 deg. I can move from the "start" to "1" OR "2" but the position for those is the same, it does not change!

Also maybe my understanding is not right, when I come out of the cyclic menu, say to the tail menu for example, and try my cyclic, I'm getting 12 deg !!! Which is way too much!! This is with the stick at mid-position.

John
Fingolf 25 January 2016 16:3325.01.2016 16:33
The 8 deg is only a reference point in the setup menu.

Stephan
duc996bp 25 January 2016 16:3925.01.2016 16:39
OK, so 8 deg is only used for that setup menu, what I actually have is seen when I come out of the menu, which is 12 deg of cyclic. That is way too much, right?
Eddi E. aus G. 25 January 2016 17:5825.01.2016 17:58
Hi,

you can not assess what's happening with a flybarless system. Without the sensor feedback, and with adaptive control loops like we have, the absolute output can only be measured in the setup mode, otherwise VBar outputs exactly as many degrees of cyclic as required (which is pretty little, by the way ;-) ) and on the ground, it outputs as much as it can, because the heli is never changing it's pitch or roll rate.

Kind regards

Eddi

Born to fly ...
forced to work.



1 mal bearbeitet. Zuletzt am 25.01.2016 17:58 von Eddi E. aus G..
duc996bp 25 January 2016 18:0425.01.2016 18:04
Ok thanks Eddie and Stephan
VStabi VStabi Pioneer of Flybarless