swalko
1 February 2016 08:1801.02.2016 08:18
What affects parameter heli size and how to set this parameter correctly?
There is inconsistency between vstabi.info manual and PC SW. In PC SW 700 class = 90, vstabi.info manual 700 class = 70. I set this value on my TDR2 based on PC SW hint to 90 . Is there some procedure how to set this parameter correctly? My TDR2 fly very nice and locked with value 90.
2 mal bearbeitet. Zuletzt am 01.02.2016 09:13 von swalko.
Eddi E. aus G.
1 February 2016 14:0301.02.2016 14:03
Hi,
this parameter more or less scales the control loop response, changes time constants. If set too low on a large, heavy, inert model, it will rebound or feel sluggish, both with the stabilization and with control inputs, because the control loop is acting too quick for the more inert/less responsive model.
The parameter must not be set very accurately to have a good control response, for the TDR II I would assume a value between 50-70 is OK.
It's also difficult to specify heli classes by the blade size, it depends on a lot more variables. For example, our 800 with 7.5+ kg auw is a different animal than an 800 of an other manufacturer.
Kind regards
Eddi
Born to fly ...
forced to work.
swalko
1 February 2016 22:1101.02.2016 22:11
Thank you Eddi for answer. So if i use 90 value on my TDR2 and i like the way how it fly, there is no reason to change it.
Eddi E. aus G.
2 February 2016 08:3502.02.2016 08:35
Hi again,
no, no reason to change it, although I think the TDR II could handle less (means, shorter time constants in the control loop).
But I have no first hand experience.
Kind regards
Eddi
Born to fly ...
forced to work.
swalko
2 February 2016 11:1002.02.2016 11:10
Hi Eddi,
today i tested parameter "Heli size" with value 50. I can say that it fly with same stability, but i feels to be more connected with TDR2, so 50 works better on TDR2 :-) .
Thank you