← VBar NEO for external transmitters

Initializing Error during setup Process translated

VBar › VBar NEO for external transmitters · Started by mkucuksari on 14 March 2016 13:1714.03.2016 13:17
mkucuksari 14 March 2016 13:1714.03.2016 13:17
After flying my new Neo at Gaui X3, I have decided to move it into my other heli. So I need to re-configure it. But before that I have updated last version, both Neo firmware and PC software.

During my last setup , I got the following error my times , "Initializing Error, Check Event Log"

This error occured mostly when I start a new Setup by pressing "Create New Version 6 Setup" and while passing from "Rotat Dir" Tab to "Swash" tab.

In order to be sure I restart the new setup (including to bind process with Spektrum) and got the following error at least 3-4 times. But when I checked the error log, I only saw two of them.

When I press "Ok, back to Setup", it normally returns and continues to work.

Do I have to worry ? Or I can use it without any problem ??

Dateianhänge:
öffnen | Download - log-20004628-13-Mar-2016-17-59-40.zip (1.5 KB)
RV 14 March 2016 14:0314.03.2016 14:03
Quote:Info 0:00 Motor Switch operated to ON
Info 0:05 Calibration Finished
Warn 0:05 Ambiguous Value on Elevator RC Channel at Init
Warn 0:06 The Cyclic Ring is active
Warn 0:07 The Cyclic Ring is active
Warn 0:08 The Cyclic Ring is active
Warn 0:09 The Cyclic Ring is active

Please check your TX calibration. Set sensor Alignment again and recalibrate rescue level state.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
mkucuksari 14 March 2016 15:4014.03.2016 15:40
I see....Sorry I forgot to tell that the unit was not fixed to the model at that time.... only temporary mounted...

So this ambiguous values cause that "Initializing Error".
Eddi E. aus G. 15 March 2016 09:2815.03.2016 09:28
Hi,

yes, it is. We expect the center position to be within a certain range of values, if it is off by too much this error message will be triggered.

Kind regards

Eddi

Born to fly ...
forced to work.
mkucuksari 15 March 2016 10:5415.03.2016 10:54
Happ to hear that. Thanks for your interest and support.

Regards
VStabi VStabi Pioneer of Flybarless