kai123
5 April 2016 10:3705.04.2016 10:37
hi,i use yge 120 lv ,and neo gov,but start up its too fast,how can set up the soft start up!
thank you
RV
5 April 2016 21:2505.04.2016 21:25
Well - the initial start is coming from the ESC (and YGE is soft here) - the Spoolup from NEO AFTER the ESC has coupled to our throttle signal. This can be set with a ramp limit of 2 instead of 3 in the gov setup. But slows down also the AR bailout recovery feature a bit.
regards (EN) / Gruss (DE)
Rainer Vetter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.
Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
kai123
6 April 2016 09:3406.04.2016 09:34
thnak you,
maybe one the yge setup airplan slow or midd ?
what recoment airplan midd?
RV
6 April 2016 10:0706.04.2016 10:07
this is how the ESC responses to our throttle signal. The start is determined with the "special Procedure" (heli mode) in the prog card.
Have you set it up with a prog card or does it support the beep modes for VGov in its manual?
You might have a look at our video section for both versions - the 90LV is the same ..
Prog Card:
http://www.vstabi.info/en/node/1476
Stick Setup (if supported):
http://www.vstabi.info/en/node/1488
regards (EN) / Gruss (DE)
Rainer Vetter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.
Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
1 mal bearbeitet. Zuletzt am 06.04.2016 23:04 von RV.
kai123
6 April 2016 22:4406.04.2016 22:44
OK,THANK YOU FOR ALL!!
FINALY SETUP CORRECT!!