← VBar NEO for external transmitters

VBar Neo gov question(s) translated

VBar › VBar NEO for external transmitters · Started by above on 21 April 2016 11:0921.04.2016 11:09
above 21 April 2016 11:0921.04.2016 11:09
Hey

At the moment the model is constantly ramping up and down during collective inputs during flight. You can really hear it. Is this the gov trying to compensate for the changes? If so, how do I correct it? Raise or lower the gain?

Any help would be greatly appreciated!
Thanks!
Eddi E. aus G. 21 April 2016 11:2121.04.2016 11:21
Hi,

you write 'at the moment' ... does this happen in flight, or only on the bench?

Did this happen out of the blue, or was anything changed?

Do you get any tell tale entries in the event log?

If only on the bench, it's a normal behavior: we add some throttle every time you input cyclic or collective, to pre-compensate for the increase in torque to be expected. Without load, on the bench, you notice that as an increase in rpm when you move the stick, in flight and with load, it will just help to keep the head speed.

If in flight, you can alter the settings for Collective and Cyclic add (Governor Expert) to find the sweet spot.

Kind regards

Eddi

Born to fly ...
forced to work.



1 mal bearbeitet. Zuletzt am 21.04.2016 11:23 von Eddi E. aus G..
above 21 April 2016 11:4021.04.2016 11:40
this happens in flight, and it is always in all models that have ridden the NEO.

So far I've solved putting (Plimit + 10) and (Plimit- 10) are in default 20

The gear ratio and motor poles are fine, (gauiX5 7.5) (scorpion 4020 1100kv 4 pairs of poles)

The heli enters very easily overspeed. I this is not normal
Eddi E. aus G. 21 April 2016 11:5421.04.2016 11:54
Hi,

well, it can happen if the drive system is powerful, so changing the above mentioned parameters would be a good starting point.

Kind regards

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless