← VBar NEO for external transmitters

Vbar neo governor settings. translated

VBar › VBar NEO for external transmitters · Started by racer-g on 24 June 2016 14:5324.06.2016 14:53
racer-g 24 June 2016 14:5324.06.2016 14:53
Hi again.
I've just set up governor according to vstabi info from here and i have a few questions if i am on the right way.
My steps was.
Lowered gov gain and integral.
Dialled in main screen requested HS(in my case heli trex 550 and hs 2150,2300)
With coll. zero checked hs(was about 1500-1700) and raised basic throttle(advansed settings) till headspeeds matches for both banks.My basic thr. became 75 and 81.
Hovered and checked HS(was more than requested).I lowered coll. add to 20 on both banks.
Made few jumps,HS didn't changed,at least i can't hear any changes.
Set back gain and I.
Lowered gain to 25.
Governor works perfect.Better than Hobbywing one.I like it.No overspeeds too.
Now my question,i am good or made any mistake?
Are basic throttle values ok?
Is coll add value ok?
Gov gain 25 is it ok?
Thanks in advance.
RV 24 June 2016 20:5724.06.2016 20:57
Seems ok here - except one thing:

Quote:My basic thr. became 75 and 81.

This is a bit much -and may indicate a undergeared heli. The Gov hasn't much headroom there if needed. Can you use a bigger pinion?

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
racer-g 25 June 2016 03:4225.06.2016 03:42
I'm already using bigger pinion 17.Main gear 170.
Any other tricks :-) ?
RV 25 June 2016 11:0225.06.2016 11:02
OK - there are always 3 possible ways if the gov hasn't much headroom at a defined HS:

- gearing up
- more cells
- lower HS

Or at least - keep it as it is and accept HS dropping under high load especially at the end of the flight.

I would expect approx. 60% in the zero collective run with a new full battery, 65 with half-full new battery and 70% at the end of the new battery.

Having 60% and 20% collective ad - we are at 80% with full collective. If we got this there are 20% headroom left for:

- keeping the HS under load during the whole flight (voltage decreases during flight)
- keeping the HS under load for lots of flights (battery gets weak during cycles)

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
racer-g 25 June 2016 15:1425.06.2016 15:14
Thanks Rainer for info.
What i've done today is dropped headspeed to 2250 and basic throttle became 79 wich is still too much i think.
And yes,i have HS drops at the end of flights.
Also i will get 18 pinion to see what happens.
Have a nice day.
My best regards.
George.
VStabi VStabi Pioneer of Flybarless