← VBar NEO for external transmitters

how do i calibtate the cc160hv to the neo using a dx9

VBar › VBar NEO for external transmitters · Started by markb75 on 22 July 2016 23:3522.07.2016 23:35
markb75 22 July 2016 23:3522.07.2016 23:35
Hi
I'm struggling to get the dx9 to calibrate its esc end points with a cc160hv using a neo, how do I do it, after 3 hours I still couldn't get it to work


mark
RV 23 July 2016 08:1523.07.2016 08:15
Mark,

why do you want to calibrate it? Everyone wants to do this always - it is a relict from history and almost not needed. Especially when the ESC arms and gives full throttle too.

Use the ESC in the Mode for VGov - and it has fixed endpoints which are known ;-)

Otherwise - if you still want to do - ste the check in Gov2 tab and the collective is mapped to throttle unless you unset it. Should work also when powering down and up (e.g. full throttle) again for teaching.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.




1 mal bearbeitet. Zuletzt am 23.07.2016 08:16 von RV.
VStabi VStabi Pioneer of Flybarless