pgrbff
12 November 2016 20:4312.11.2016 20:43
Why would one use the VBar NEO + gyro over a VBar NEO alone?
Sorry, I have been out of the loop for a while now. I have just started flying my Logo 500SE with mini VBar again after 4 years not flying.
pgrbff
15 November 2016 07:2015.11.2016 07:20
Surely someone can take one minute to explain? Please !!!
Eddi E. aus G.
15 November 2016 09:4815.11.2016 09:48
Hi,
you would want to use the external gyro for two, maybe three reasons:
a) you have a model with very high or adverse vibration level, which would cause the internal gyro sensors of the NEO to show drift while flying the model. The external sensor has a different sensor technology, which is less affected by vibration (or affected only by different vibration, so you have a choice).
Mind that if the vibration level is that bad, also the Rescue sensors can be affected, and they are only in the NEO.
This usually only happens on nitros, so you could say if you have issues on a nitro, use the external sensor, but be careful with the Rescue feature.
b) you want redundancy, means in case the external gyro sensor fails or gets disconnected, you still have the internal gyro sensor as a fall back/backup.
c) you want to place the sensor where you could not place the NEO itself, and maybe even mount the NEO itself not square face up, face down but e.g. to the side frames etc., but then be warned _if_ the sensor function would fall back to the internal sensors, things get exciting, as well as if you would want to use the Rescue feature.
The NEO's sensors are way better with regard to vibration issues than any generation of this type of sensors before, and they have a better resolution.
The external gyro sensors (Silverline type) are even less perceptive to vibration (certain or different vibration levels and frequencies/amplitudes) than the internal gyro sensors. Addendum: there is no one-fits-all solution, and even though the external sensor is tougher, it's not bullet proof ;-)
Bottom line, on a LOGO, no need. On most other models, no need. Even on nitros, probably no need (my colleague flies a 600N and even a VARIO Gasser only with the NEO's internal sensors, no issues).
Kind regards
Eddi
Born to fly ...
forced to work.
WFEGb
15 November 2016 09:5715.11.2016 09:57
Hello Eddi,
what's about the need of an extra sensor for use in a turbine-heli?
Best regards,
Werner
Eddi E. aus G.
15 November 2016 10:0315.11.2016 10:03
Hi Werner,
well, the silverline type of sensor (also sold with the NEO) is approved for use on turbines. But experience has it that the NEO works on turbines without issues, the operating frequency of the sensors is way different than before so vibration which could have caused earlier generations of sensors to drift should not affect the NEO any more. This has been underlined by experience now, quite a few turbines are flying with the NEO only already.
So I would say the same applies, if you have no drift effects with the NEO only, no need for the external sensor (but the reasons given).
Kind regards
Eddi
Born to fly ...
forced to work.
pgrbff
15 November 2016 10:5915.11.2016 10:59
Thank you for a most comprehensive reply.