← VBar NEO for external transmitters

Futaba T18SZ Motor Idle translated

VBar › VBar NEO for external transmitters · Started by ConnorSloan on 30 December 2016 12:5430.12.2016 12:54
ConnorSloan 30 December 2016 12:5430.12.2016 12:54
Hi guys,

Just a quick question, just set up my model, everything is working perfectly except my motor idle, (3 position switch) , Position1=run, Position2=Hold(idle), Position3=Hold(off), I go from position3(off) to position1(run) but when I want to do an auto (with bailout working) I go to postion2(idle) but the model is still running? I then have to go to postion3(off) (no bailout) for it to actually stop the model from running?

any ideas how i can get position 2 working correctly?

(Vbar Neo)

Many Thanks,
Connor Sloan



2 mal bearbeitet. Zuletzt am 30.12.2016 16:16 von ConnorSloan.
RV 30 December 2016 20:1130.12.2016 20:11
Quiet normal with VBar gov running it in low HS in AR to get a fast spoolup.
Value can be set in PC soft flight panel, gov section.

Is it VGov or "Others"? Which ESC, Mode? How many % are set in the named field above?

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
VStabi VStabi Pioneer of Flybarless