trexian
11 June 2017 16:5611.06.2017 16:56
Hi
I Have a brand new neo and have set it up on two spektrum dsmx sats. the pc program says it is bound and all channels have been set and show they are working.
However no output to servo's is found.
Any help would be appreciated.
ian
Fingolf
11 June 2017 17:5711.06.2017 17:57
Have you finished the setup?
Servo output is locked without a completed setup.
Stephan
trexian
11 June 2017 18:4311.06.2017 18:43
Hi
I cannot complete setup because the servo's dont move
Ian
Fingolf
11 June 2017 19:0911.06.2017 19:09
Do a new setup and finish them.
trexian
11 June 2017 19:1511.06.2017 19:15
I have tried this but still won't work
RV
11 June 2017 23:2011.06.2017 23:20
Again - did you do a new setup correctly by hitting the "Create new Version 6 Setup" button on the first setup page?
If yes - are the servos plugged in correctly?
regards (EN) / Gruss (DE)
Rainer Vetter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.
Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
Eddi E. aus G.
12 June 2017 12:2312.06.2017 12:23
Hi Ian,
to explain in more detail: only if you click "Create new Version 6 Setup" on the first panel of the setup, initial factory parameters are written into the VBar and the servo output will be enabled. If you skip this and just go through the setup, the 'error pattern' is exactly as you describe. Same if you just load an existing setup into a virgin VBar NEO ... every NEO needs that button clicked at least once ;-)
Cheers
Eddi
Born to fly ...
forced to work.
trexian
12 June 2017 14:0712.06.2017 14:07
Thanks i will give it a go and let you know.
Ian
trexian
12 June 2017 20:0312.06.2017 20:03
Thanks Eddi it worked my bad.
just did a new setup and all ok.
Thanks
Ian
Eddi E. aus G.
13 June 2017 09:1913.06.2017 09:19
Hi Ian,
no worries :-) you are not the first and certainly not the last ;-)
Note to ourselves: add one or two lines of text to the description on the first panel :-)
Cheers
Eddi
Born to fly ...
forced to work.