← VBar NEO for external transmitters

Aux 3 on Throttle translated

VBar › VBar NEO for external transmitters · Started by DJB on 6 July 2017 18:1706.07.2017 18:17
DJB 6 July 2017 18:1706.07.2017 18:17
Hi all, can anybody give me information on how to setup my Neo in order to use my throttle curves and not gov.
My radio is a DX8 with Neo pro on a logo 400.
Have read the chapter on alternative wiring using Aux 3 and more detail is required please.
Regards
Dave
Eddi E. aus G. 19 July 2017 10:0119.07.2017 10:01
Hi Dave,

if you connect the esc or throttle servo to AUX 3 and assign the throttle channel # from your radio to it (see gauge and checked if the ESC reacts/a connected servo moves with the collective/throttle stick—throttle must not in hold or cut, then). Now you have direct control over the ESC or throttle servo and can use throttle curves and the engine/throttle logic of the radio, VBar has no more hands in it.

I would still recommend you assign a spare channel to the motor switch, outputting the state the model is in: RUN = powered and IDLE or OFF = not powered, depending on the current flight condition/flight mode, so the VBar 'knows' if the model is powered or not, and so it logs (which could help with trouble shooting).

Check that fail safe works properly, the motor must stop if you either turn off the radio (run the mechanics without blades, on the bench), or if you disconnect the last satellite.

Kind regards

Eddi

Born to fly ...
forced to work.



2 mal bearbeitet. Zuletzt am 19.07.2017 10:04 von Eddi E. aus G..
VStabi VStabi Pioneer of Flybarless