galensk
25 September 2017 11:3425.09.2017 11:34
Hi,
We're struggling a bit to get good governor response on a TREX700 with castle 160A ESC.
Bank 1 : 1900rpm --> Here we see :Governor is at Low Throttle Limit
Bank 3 : 2100rpm --> Here we see :Governor Full Throttle
We tried several settings in de Governor tab but seem to miss something. Any hints ?
Regards,
Kurt
Dateianhänge:
öffnen |
Download -
Sun Sep 24 20.pdf
(120.5 KB)
Eddi E. aus G.
25 September 2017 11:4225.09.2017 11:42
Hi Kurt,
how's the ESC set up? Please see
here.
If—for whatever reason—the endpoints or something else are not set up properly, the useful range of values for the throttle opening could be limited.
Kind regards
Eddi
Born to fly ...
forced to work.
galensk
25 September 2017 13:0725.09.2017 13:07
Hi Eddy,
Thanks !
The pilot runs on Futaba..., we wil redo the throttle calibration first to be 100% shure.
Regards,
Kurt
Eddi E. aus G.
25 September 2017 13:1625.09.2017 13:16
Hi Kurt,
even with Futaba, if you want to use the VBar Governor, you would have to set the ESC accordingly using the Castle software, with that it's all set.
Kind regards
Eddi
Born to fly ...
forced to work.
galensk
25 September 2017 16:2125.09.2017 16:21
Just to know... is there a good procedure to learn the ESC VBAR_NEO throttle output range, when not using the VBAr control ? (I know.its easy with the VBAr control :-) )
Eddi E. aus G.
25 September 2017 17:0425.09.2017 17:04
Hi,
yes, Gov. II / Throttle Servo Adjustment ... same shit, different island ;-) or so they say, in the Caribbean ...
Best,
Eddi
Born to fly ...
forced to work.
1 mal bearbeitet. Zuletzt am 25.09.2017 17:05 von Eddi E. aus G..
galensk
30 October 2017 14:0230.10.2017 14:02
Sorry for the late update... we found the island :-) ! Caribbean "adjustment" works great. :-) thank you for the support !
Kurt