← VBar NEO for external transmitters

NEO WITH EXTERNAL SENSOR SWASH DEVIATION translated

VBar › VBar NEO for external transmitters · Started by galensk on 11 December 2017 13:0911.12.2017 13:09
galensk 11 December 2017 13:0911.12.2017 13:09
Hi,

We're setting up an F3C machine with VBAR NEO + external sensor. The problem is that after levelling the swash in the setup procedure the swash tilts a little backwards after power cycling the NEO. We could only get it right by giving an offset in the setup ? It's little worse at max positive and max negative compared to zero pitch.

TX values +/- 100 are correct in the setup wizard. We tried with and without external sensor...

Transmitter is a Jeti DS-16

Any hints ?

Regards,
Kurt
RV 11 December 2017 17:0711.12.2017 17:07
Just use the internal sensor - it is more precise (has more resolution) - so no need for external ones.

If the external one have a slight center offset to the NEO - this may happen. We use internal one for Init Check and setting center values.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
galensk 12 December 2017 17:1312.12.2017 17:13
Hi Rainer,

Thank you, we will eliminate the external sensor and redo the setup :-)

Regards,
Kurt
Eddi E. aus G. 13 December 2017 09:0013.12.2017 09:00
Hi Kurt,

I'm curious if there are still values saved in the trim flight memory. In setup, they are ignored (so you can set up and measure properly), once you exit setup they will be added. If you (C)ancel them, there should be no twitch, no matter which sensor is being used.

But I second Rainer's suggestion, if you don't need the external sensor for specific reasons, leave it out.

Kind regards

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless