ruudm
11 February 2018 19:5411.02.2018 19:54
Hi
swapped out mini bar for Neo on my dad's trex 450 and all works flawless.
transmitter DX8 (old model) setup like on website with rescue on trainer button.
since he have not flown for more then a year we would like to have the beginner mode aswell is this possible and how?
or only possible on VControl?
regards Ruud
Eddi E. aus G.
12 February 2018 09:0112.02.2018 09:01
Hi Ruud,
it's possible of course.
Check out the function of the Rescue feature: it has three positions: Rescue—Off—Beginner. So you would need a 3-point-input, like a three-position-switch. At best one which is spring-loaded to one direction (for Rescue) and has fixed positions for the other directions (Center=Off, and Beginner-Position).
I am not familiar with the programming of the DX 8 any more, but it could even be possible to use the trainer button for Rescue (overriding a different two-level switch, which switches between Of and Beginner). Just mind that then, you would need a slight delay on that control channel, like 0.5 secs, so the radio makes a for the VBar noticeable transition from Rescue through Off to Beginner, to re-arm Rescue, if you push the button and release it.
If you switch directly between Rescue and Beginner, and Off (center position) is not detected by the VBar, it would not re-arm Rescue.
Or you find a suitable 3-position-switch for the '8, and replace one of the 2-possition switches at the front, then it would be as intended on VBar Control.
Kind regards
Eddi
Born to fly ...
forced to work.
ruudm
13 February 2018 07:4513.02.2018 07:45
Thank you Eddy, i will give it a shot :-) .have the same problem as you, have no used DX8 for long time ;-) .. myself is on Vcontrol
1 mal bearbeitet. Zuletzt am 13.02.2018 07:46 von ruudm.
ruudm
13 February 2018 20:5613.02.2018 20:56
ok i found out that rescue settings are ad the swash plate menu ;-)
that you can select rescue+beginner and when you change the travel to 40+% beginner mode is activated.
i can't find how to get 2 switches for aux3, so one is for beginner on-off (40% and 0% aux3 travel) and the trainer knop that is springrelease 100% aux3 for resque
but then the eureka moment came .. how about banking? on the old v bars i can remember you have to setup each bank separate.. but i can't find how on the neo ;-)
so can i activate per bank rescue / beginner / normal mode
so bank 1 = normal + rescue
bank 2 = normal+rescue
bank 3= beginner + rescue
annyone?
Eddi E. aus G.
14 February 2018 08:4614.02.2018 08:46
Hi,
switch assignments like channel assignments are global, from the VBar's perspective.
If you want different configurations, you can do it with flight conditions in the radio, make the channel assignments/travels per flight mode.
But mind that you want to have 0 % (center/Rescue Off) at least intermittently. If you have your Beginner switch set to Beginner (make it –100 %, not just beyond the like 1/3 thresholds between –100...0...+100, which would be around –34 and +34 if you divide 200 by three and adjust), and you trigger Rescue, and it will just fall back to Beginner without passing through center/0 % at least briefly, Rescue might not re-arm.
Kind regards
Eddi
Born to fly ...
forced to work.