← VBar NEO for external transmitters

Re: T-Rex 700 with mini-VBar and 2 Spektrum satellites translated

VBar › VBar NEO for external transmitters · Started by charlzwilliams on 20 September 2018 01:1120.09.2018 01:11
charlzwilliams 20 September 2018 01:1120.09.2018 01:11
Anyone with instructions for binding vbar neo with spektrum DX9 11 ms digital servos. Unable to get DX9 to bind at any setting.
Eddi E. aus G. 20 September 2018 09:0420.09.2018 09:04
Hi,

as simple as clicking 'Prepare for Binding' and briefly (< 1 sec) power cycle the VBar, so the sats will start flashing quickly.
If this doesn't work, try a different power supply or even a receiver battery and nothing else connected, if there are capacitors in the electric circuit which keep the voltage for some time, or only slowly discharge, they interfere of course.

Once the sats flash quickly, turn on your radio with the bind button depressed, and the radio will do it's job, it's a matter between radio and receiver(s) anyway, the VBar has no hands in it but preparing the sats, bringing them into bind mode.

If it doesn't work, increase the distance between radio and sats (3 ft/1 m might be required, or else near field noise of the high powered radio may interfere—VBar Control has a near field mode where power is reduced, other radios might not have that feature).

If it doesn't work, try 22 ms, not everything which may be advertised might work, if the radio and the sats only negotiate 22 ms, that's the way it is, again the VBar has no hands in it.

Kind regards

Eddi

Born to fly ...
forced to work.



1 mal bearbeitet. Zuletzt am 20.09.2018 09:04 von Eddi E. aus G..
VStabi VStabi Pioneer of Flybarless