← VBar NEO for external transmitters

Nitro gov, NEO, Spektrum DX18 translated

VBar › VBar NEO for external transmitters · Started by Wingspinner-2007 on 6 September 2018 17:4206.09.2018 17:42
Wingspinner-2007 6 September 2018 17:4206.09.2018 17:42
Hello. I am helping a friend set up his new NEO running nitro gov. He is using a Spektrum DX18 transmitter. For Bank 1, he wants direct servo control. We have motor idle and auto rotate idle working. But the throttle servo does not begin to move from the idle position until the collective stick is moved passed 50% stick travel. Is there a remedy for that? On my silver line using VBC, my direct throttle in bank 1 moves proportionally with the collective stick up to about 3/4 throttle on my carb.

I believe the throttle servo is controlled by the collective when setting up the endpoints for throttle servo travel. What signal or “channel” controls the throttle servo when Vbar is set up for direct throttle control? The reason I ask is because it doesn’t seem like my friend’s throttle servo travel is proportional to the collective travel.

Thanks
RV 6 September 2018 21:5206.09.2018 21:52
The throttle is driven by collective stick then. Does this stick have -100 ... +100 at the live display - or does he have a curve?

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
tb 6 September 2018 22:0406.09.2018 22:04
Have you set up the direct throttle for bank 1 in the gov 2 menu?
Mark Norris 17 October 2018 22:5917.10.2018 22:59
Hi Wingspinner-2007,

In Addition to the previous post stating "Have you set up the direct throttle for bank 1 in the gov 2 menu?"

I had the exact same issue on my Vbar Neo with a spectrum DX8G2.
The issue for me was in the Vbar Neo PC software under setup and under the receiver tab. The "motor" isn't actually the motor channel, it should be assigned to a switch 3 pos switch that enables the motor to be in 1 of three states (off / idle / run). Once you assign the "motor" channel to a 3 position switch and set it to RUN -your direct throttle on bank 1 will work.

Mark



2 mal bearbeitet. Zuletzt am 17.10.2018 23:13 von Mark Norris.
VStabi VStabi Pioneer of Flybarless