Hello,
I have a new Synergy N7 helicopter that I have around 20 flights on. Recently I've noticed an unusual aileron (side to side) wobble that persists throughout my headspeed range (1700 - 1900), this is something that just started recently without changing anything on the helicopter. The engine is currently running a tad rich but not sure if this can cause side to side wobble.
Setup is:
Synergy N7 helicopter
Vbar NEO with pro / rescue using supplied tape, no external sensor
OS 105 pumped engine on 15% nitro (too much power :-) )
Synergy Rail blades 696 and 96, perfectly balanced by me
3 Xpert KD1 Cyclic Metal Gear Brushless Servo (High Voltage) for cyclic
1 Xpert KD1T Tail Metal Gear Brushless Servo (High Voltage) for tail
1 Xpert KD1E Kyle Dahl Pro Tune High Speed Brushless Throttle Servo (High Voltage) for throttle
It definitely looks like once it starts to shake the swash servos may be aggravating things as the side to side movement is fairly extreme. I have lots of raised vibration levels in the log and there is some bubble in the gas tank.
I'm currently chasing down mechanical sources of vibration however I'm wondering if the VBAR NEO is capable of causing this alone. Can you suggest any troubleshooting suggestions either mechanical setup or NEO software config.
I don't really fly 3D and just like scale type flying, my VBAR rotor settings are currently:
Style 80
Agility 80
Gyro Gain 80
Paddle sim and pitch pump @Zero.
Thanks
Mark Norris
I have a new Synergy N7 helicopter that I have around 20 flights on. Recently I've noticed an unusual aileron (side to side) wobble that persists throughout my headspeed range (1700 - 1900), this is something that just started recently without changing anything on the helicopter. The engine is currently running a tad rich but not sure if this can cause side to side wobble.
Setup is:
Synergy N7 helicopter
Vbar NEO with pro / rescue using supplied tape, no external sensor
OS 105 pumped engine on 15% nitro (too much power :-) )
Synergy Rail blades 696 and 96, perfectly balanced by me
3 Xpert KD1 Cyclic Metal Gear Brushless Servo (High Voltage) for cyclic
1 Xpert KD1T Tail Metal Gear Brushless Servo (High Voltage) for tail
1 Xpert KD1E Kyle Dahl Pro Tune High Speed Brushless Throttle Servo (High Voltage) for throttle
It definitely looks like once it starts to shake the swash servos may be aggravating things as the side to side movement is fairly extreme. I have lots of raised vibration levels in the log and there is some bubble in the gas tank.
I'm currently chasing down mechanical sources of vibration however I'm wondering if the VBAR NEO is capable of causing this alone. Can you suggest any troubleshooting suggestions either mechanical setup or NEO software config.
I don't really fly 3D and just like scale type flying, my VBAR rotor settings are currently:
Style 80
Agility 80
Gyro Gain 80
Paddle sim and pitch pump @Zero.
Thanks
Mark Norris