← VBar NEO for external transmitters

Looking for VPlane information translated

VBar › VBar NEO for external transmitters · Started by Mark Norris on 27 November 2018 03:1027.11.2018 03:10
Mark Norris 27 November 2018 03:1027.11.2018 03:10
Hello,
I've just purchased a VControl Touch radio for my helicopter; however I also have airplanes and would like to investigate using the VControl for all my models. Can I use telemetry from a Castle ESC, any setup information regarding NEO and VPlane Professional would be helpful.

Thanks



1 mal bearbeitet. Zuletzt am 27.11.2018 03:32 von Mark Norris.
Vinger 27 November 2018 04:1027.11.2018 04:10
You need to use an UI for Castle ESCs as they are not directly supported for telemetry. VPlane is very easy to setup , just follow the wizard and the information is all on this website under Vplane.

VControl, VBar on all.
TDR, TDR2, TDF, TDS and TDSF
Peter
Mark Norris 27 November 2018 23:4027.11.2018 23:40
Hello Vinger,
What is an UI, is it this (http://shop.mikado-heli.de/VBar-Electronics/VBar-Control-Accessories/Current-Voltage-Capacity-Sensor-VBar-Control.htm?shop=k_mikado_e&SessionId=&a=article&ProdNr=04890&t=7568&c=7757&p=7757).

Also is there simply a VControl receiver that can be used without any of the "fancy" stuff included in the NEO, can I use a NEO and simply turn off all the special features so it will resemble a standard receiver?

Thanks



1 mal bearbeitet. Zuletzt am 28.11.2018 00:00 von Mark Norris.
Vinger 28 November 2018 03:5628.11.2018 03:56
VBasic is available as a simple RX, can be upgraded to a fully functioning Neo as well. Correct on the UI.

https://www.vstabi.info/en/vbasic

https://www.vstabi.info/en/node/1779

Above links is for the VBC, but the VBCt has all the same functions just a different user interface and a few extra functions.

VControl, VBar on all.
TDR, TDR2, TDF, TDS and TDSF
Peter
VStabi VStabi Pioneer of Flybarless