← VBar NEO for external transmitters

Wiring for Beastx rpm sensor translated

VBar › VBar NEO for external transmitters · Started by Ianflorio on 18 January 2019 10:0218.01.2019 10:02
Ianflorio 18 January 2019 10:0218.01.2019 10:02
Hi,

I think I know the answer to this question but I wanted to make sure. I have an Align/Beastx rpm sensor (Part no. HEGBP001T). I need to replace the plug to use it with a NEO on a Nitro helicopter, please can you confirm the wiring. White - I'm guessing is the signal, but which way around do I need to put the black and red wires on the new plug I'm going to solder on? With the old Align sensors I know you had to swap the red and black around but the plug currently fitted is a 6 pin plug similar to the tele port plugs but bigger and doesn't seem to conform to anything else I've seen before.

Thanks in advance

Ian
Eddi E. aus G. 18 January 2019 11:2018.01.2019 11:20
Hi Ian,

in general, if not specified otherwise, white or orang is signal, red positive, black or brown ground. The order is like on any servo type connector, on the VBar. You can make up an adapter or solder a half-patch-wire to the wire from the sensor, or crimp corresponding connectors, whatever suits you better.

With the two wires from HEGBP001T, red and black, my best guess would be black is ground (that's like a common denominator, in electrics/electronics), so red must be the signal wire.

Kind regards

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless