← VBar NEO for external transmitters

Vbar Neo setup with YGE 90LV translated

VBar › VBar NEO for external transmitters · Started by MikeSteed on 1 April 2019 16:5101.04.2019 16:51
MikeSteed 1 April 2019 16:5101.04.2019 16:51
Hi All,
I hope someone can help me. I am relatively new to the NEO and I am setting up a LOGO 550 with the YGE 90LV ESC which was previously running on a Vbar mini. Everything has gone well but I am confused with the connecting of the slave lead from the ESC to the NEO in order to use the NEO internal governor. Does the slave lead connect to the RPM input or the SENSOR input? I would like to clarify this as I would hate to fry the NEO.
GregCA 1 April 2019 18:1001.04.2019 18:10
Combine the RPM pin and the 2 slave BEC pins (power and ground) into a single connector and plug it into the NEO RPM port.



1 mal bearbeitet. Zuletzt am 01.04.2019 18:15 von GregCA.
MikeSteed 1 April 2019 19:1801.04.2019 19:18
Thanks for the quick reply. I'll give that a try. Didn't want to take any chances before checking. Cheers.
VStabi VStabi Pioneer of Flybarless