above
17 April 2019 16:3917.04.2019 16:39
Hello, I would like to know how many RPM the Vbar Neo governor can deliver, to know the pinion that I have to put in order to have a good pwm.
I explained myself well ?
Thank you for your attention
Eddi E. aus G.
18 April 2019 08:4618.04.2019 08:46
Hi,
actually, if the target head speed can be calculated, there is no real limit.
The max. head speed your drive system can deliver depends on the voltage x cell count x kV (of the motor) / main gear x pinion.
To calculate the head speed from the rpm sensor readout (external rpm sensor or ESC with rpm signal output), all you need is the half pole count of the motor and the actual gear ratio, job done.
In case the gear ratio is > 12.7, double the pole count and halve the gear ratio, e.g. if you have an 8 pole motor, usually you would enter 4 poles and (in this particular example) 14 as a gear ratio (> 12.7). Since 14 is out of the range of values for the VBar's internal calculation, you would enter 8 poles and 7 as a gear ratio, voilà.
The PWM or throttle opening depends on the above calculation of the max. head speed, too, but it's no exact science.
For my purposes, I always calculate with the above formula (and with 3.6 V/cell under heavy load and with the battery voltage decreasing, as an average), and add a factor of 0.8 (for 6s setups) and 0.9 (for 12s setups).
This way I get a PWM or throttle opening of the ESC of 65+ (battery fully charged), and of course more (up to full throttle) (battery discharged), but—given good batteries—the system can maintain the head speed from battery full to battery empty, I get no considerable head speed drops even then, and no log file entries 'governor at full throttle' which would indicate the system can no longer maintain the requested/target head speed even at full throttle.
Savvy?
:-)
Kind regards
Eddi
Born to fly ...
forced to work.
1 mal bearbeitet. Zuletzt am 18.04.2019 08:47 von Eddi E. aus G..