← VBar NEO for external transmitters

Configuring Koby governor with Vbar NEO translated

VBar › VBar NEO for external transmitters · Started by Arag_ on 6 June 2019 14:5206.06.2019 14:52
Arag_ 6 June 2019 14:5206.06.2019 14:52
Hello,
I am planning to build an heli using a Kontronik Koby 90LV with a VBar Neo Express (non VLink) using a DX18 transmitter.
I have been reading in vstabi information in order to know how to configurate using the Kontronik gov instead the VBar gov, but I am confused how to configure it.
I guess it is not necessary to use an external rpm sensor, right?
Second, what should be the wiring of the ESC in the vbar, using the ESC input or the EXT3 input?
In the TX I used to configure an interrupt for Hold mode and another interrupt for Throttle Cut mode (that way is almost impossible the motor starts by accident). If I have understand good another thread in this forum, I guess I could use the Throttle Cut interrupt to assign the Throttle channel in the vbar setup, but what channel should I assign to the Throttle stick?
Finally, in the vbar setup (tabs Gov 1 and 2) what should I setup?

Thanks in advance for the support.

Cheers,
JC



1 mal bearbeitet. Zuletzt am 06.06.2019 14:54 von Arag_.
Eddi E. aus G. 6 June 2019 15:3006.06.2019 15:30
Hi,

to run the Koby's governor, you don't need an rpm sensor. Only if you wanted an RPM display on your radio, but then you would have to add a Spektrum telemetry module, too, and bind it together with the satellites.

You can either use the VBar NEOs throttle logic, motor switch, bank switch, three throttle percentages for three banks or flight modes (connect to ESC, then), or you can run the ESC off your radio's throttle curves, then connect to AUX3 and assign the throttle channel number to it, in the setup software.

If you use the VBar's throttle logic, you only need two switching channels (motor, bank), the throttle channel usually remains unused.
If the switching logic allows, you can have a secondary safety/kill/hold switch, overriding the motor switch, but I'm not familiar with the DX18.

In Gov I, you select external governor, that's it. In Gov II, you can enable collective stick control, to program the ESC (stick programming, beeps).

Best,

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless