Hi,
what you see is part of the control loop, there are all kinds of gizmos active which can only live out if the model is free in the air and the VBar has sensor feedback. You can only monitor the true swash plate movement if in Setup, in the PC Software or in the Setup Wizard, in VBar Control.
If nothing binds, all is well. Here's something about
geometry.
The flybarless conversion on your model is, to be honest, not well conceived (by design).
The bell cranks seem to have a gain of like 1:1.6 (servo travel:swash plate stroke), which was necessary in the past where the collective pitch compensator and flybar levers were taking out the gain again, but which is counter-productive now. You have to take out the built-in mechanical gain electronically, which leaves the servos kind of in wrong gear. 100 % of travel : 1.6 = 62.5 (it's not quite the 50 you have to adjust for, but that's because of the overall geometry at the 8° we calibrate for).
To get a better collective resolution, you could try and move the ball links in, on the servo arm (you have to put up with some binding in the push/pull, then, but that's most probably negligible, or you could also drop the push or the pull, leaving only one link connected). There seems to be no way to exchange the bell cranks for ones without a ratio (1:1 input : output).
Cyclic with 85 would be OK.
But in the end, even with 50 collective the model will fly, and most probably well enough, it's just that you could expect more from the VBar's performance if the servos could breathe more freely.
By the way, adjustable servos would not help either. You would just trade one electronic limitation for the other, make the numbers look better, since servos usually are designed/geared for their quasi-standard travel of like +/– 45°-60°. Electronics can never beat physics ... and it's not a feature of the VBar NEO but of all systems, even if you would fly without stabilization, using a regular receiver, the limitation would be necessary, and the result/performance would be equally inferior than if the geometry was better.
Kind regards
Eddi
Born to fly ...
forced to work.
1 mal bearbeitet. Zuletzt am 03.07.2019 09:19 von Eddi E. aus G..