← VBar NEO for external transmitters

Throttle Direct translated

VBar › VBar NEO for external transmitters · Started by johnpssa on 21 November 2021 13:0021.11.2021 13:00
johnpssa 21 November 2021 13:0021.11.2021 13:00
Hi, hope you may be able to help.
Vbar Neo Pro with Futaba Sbus and T7C transmitter.

Setup as Vstabi information, banks linked to idle up switch, throttle hold and cut working.
When I set idle/bank 2 and 3 to flat line curve above 66% throttle servo creeps as expected.

The only issue is throttle direct, I have this selected for idle/bank 1 and set for linear 0 - 100 curve.
When I move the throttle nothing happens until the 66% RUN point is reached.
You can also see in the transmitter tab - which is stop, idle, run as you move the stick.

I understood that throttle direct would follow the throttle curve as set in the TX so 0% - 100%

Any help would be appreciated.

Regards
John
johnpssa 21 November 2021 14:4521.11.2021 14:45
Update, It appears that I have managed to get the servo working.
Setting the idle/bank 1 to a flat line above 66% and selecting throttle direct appears to work.

Feels odd having a normal curve 70% - 70% I assume the actual curve is coming from the Neo.

I would be grateful if you could confirm that this is how it should work.

Regards
John
VStabi VStabi Pioneer of Flybarless